Skip to main content

Klaran Water Disinfection ROI Calculator

Klaran Water Disinfection ROI Calculator

Calculate Your UVC LED Requirements

Designing water disinfection systems with UVC LEDs can be a challenge because the type and quantity of UVC LEDs needed will vary based on the unique intricacies of each system. We created the UVC LED Requirements Calculator (below) to help answer an essential question for design teams: How many UVC LEDs are needed for your point-of-use water purification system to provide disinfection at its specified end-of-life?

Note: this calculator assumes configurations appropriate for low-flow systems. If you are designing for higher flow rates (greater than 4 liters per minute) please contact us and one of our field application engineers would be happy to help.

Calculate Your UVC LED Requirements

Designing water disinfection reactors with UVC LEDs can often be challenging for design teams because LED requirements vary with system elements. Complete the fields in this calculator to achieve a sense of the disinfection time, total UVC power and number of LEDs required for your point-of-use water disinfection system.

Note that this calculator assumes configurations most appropriate for low flow systems. If you are designing for higher flow rates (greater than 4 liters per minute) please contact us and one of our field application engineers would be happy to help.

Please enter the performance requirements, water quality and material characteristics of your POU water disinfection system or appliance.

Enter Flow Rate (Liters Per Minute) - Values Should be 0.2 to 4.0
Select treatment performance goal (UVC dosage)
Select Water Source (UVT)
Select Chamber Material (Reflectivity)
Select Appliance or Product Lifetime (Years)
Please make sure all entries have valid values.
Please make sure Flow Rate is between 0.2 and 4.0.

Results


CALCULATED PERFORMANCE DATA
LED Operation Time for Full Product or Appliance Lifetime
HOURS
Beginning of Life Output Power
mW

Recommended UVC LEDs
Number of LEDs
30 mW (Part KL265-50R-SM-WD)
 
 
40 mW (Part KL265-50S-SM-WD)
 
 
50 mW (Part KL265-50T-SM-WD)
 
 

Learn more about the Klaran WD Series that is right for your product.


Want to see how much it would cost to disinfect a liter of water in your system?

Complete this form and to see an estimated cost-per-liter of disinfected water in your system over the full lifetime based on your entries above.

The information collected with this form is stored by Crystal IS and will be used for us to respond to your request. You may request access to, correct, remove, or restrict the use or disclosure of any information about you that has been collected and stored by Crystal IS. For more information about how we use this information, please review our Privacy Policy.

 
 
Based on the requirements you’ve provided, the disinfection cost-per-liter of water in your system would be:
US$ per-liter.